![]() NOTE: The lights we link to above are a pack of 25. Then we cut out the outline of the letters, taped them onto our plywood, and traced around them using a yardstick as a straight edge.ĭrillBefore removing the paper, you'll want to use the hole center guide we included in the template download to mark where to drill each hole. We taped together the template, which is easier said than done, at least when you have a cat. These are PDFs that will print out on several pages and be the right size to cut out a 2-foot tall letter. We made printable templates for every letter (you can download them here). These guides will make more sense once we get further along in the project, but trust us, you'll want to have them! This will show us where the plywood is from the outside of the flashing.īoth of these measurements are based on using 3/4" plywood. We cut another piece of scrap wood to be 3-3/8" long and drew a line at 2-5/8". Next we’re going to make a height guide to help us nail in the right location. ![]() We used our miter saw, but a jig saw works too, just cut slowly (and maybe use a clamped-on straight edge as a guide). These will hold up the letters to the correct height for nailing in the metal flashing later. We're going to make a few wooden blocks to use as guides.įirst, we cut four 2-5/8" long blocks out of some scrap 2x4s. This step is a tiny bit of up front work that is going to make things way easier later in the project.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |